DRIVESHAFTSUPERSTORE

World Class Driveshafts

SALES and TECH HELP
800-845-6326 602-253-8006 

Customer Service for order status and repairs 888-222-8610

602-253-8208

FAX

602-252-5638

ADDRESS       

2417 WEST Lincoln St Phoenix AZ 85009

 

 

 

 

 

Catalogue

Customer Service

Contact Us

About Us

4x4 Links

4x4 Gallery

4x4 Videos

4x4 Babes

 

World Class Driveshafts

SALES and TECH HELP
800-845-6326 602-253-8006 

Customer Service for order status and repairs 888-222-8610

602-253-8208

FAX

602-252-5638

ADDRESS       

2417 WEST Lincoln St Phoenix AZ 85009

 

Available Tools


Mechanical Angle Finder

   This angle finder is recommended over gravity or bubble angle finders because it doesn’t required all relative objects being used to measure angles to be parallel with each other. It will give you an accurate measurement even if the objects are upside down. The gravity angle finder will not give you an accurate reading unless all the planes being measured are parallel with each other or that you know all the angles of each plane. That is, the ground is level? The body of the vehicle is level with respect to the ground? Is the transfer case output shaft level? Etc..

     

 

 

          PRICE: $18.00  

 



Pointed Grease Adaptor
    This adaptor is press on to the grease gun and used to grease all flat zerks as well as all other protruding zerks

     
     

                     PRICE : $18.00

 



U-Joint Remover

    When the u-joint is secure on one side, this tool is used to press the yoke on the tube down ward. Then it is flipped over and the same is done on the other side pressing the bearing caps out of the yoke ears and thus removing them from the drive shaft.


  

      

                       PRICE : $35.00

 


 



Universal Tie Rod End Long Socket
   This is a long socket to remove the tie rod ends off of steering racks with removing the rack. A ratchet or an air gun can be used to remove the arms. The opposite end is a universal socket that takes care of the different bolt sizes on the steering rack. This tool can be professionally finished with any color. The piece you see here is unfinished. The length is an overall 15 inches end to end.

                           Price : $45.00 (Unfinished)


 
 

ANY UJOINT OF OURS BREAKS IN TWO WE REPLACE IT FREE OF CHARGE